Jump to content

ELL Pin headers configuration


beholmes2004
 Share

Recommended Posts


[align=left]I am wondering if it might be possible to power the ELL externally. i.e from a wall plug-in 9VDC converter. If i know what pins to attach to, this should be doable?[/align]
[align=left]However reading from the manual, here is all i could gather.[/align]
[align=left]Pin Headers[/align]
[align=left]No connections should be made to the two pin[/align]
[align=left]headers on the circuit board. One of these headers[/align]
[align=left]is used to program the transceiver at the factory.[/align]
[align=left]The other is reserved for possible future versions of[/align]
[align=left]the software to provide a limited number of[/align]
[align=left]input/output ports.[/align]
[align=left] [/align]
[align=left]Thanks again[/align]
[align=left]Ben[/align]
[align=left] [/align]

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...