oilmoney Posted November 4, 2014 Share Posted November 4, 2014 Hi, I tried to test my 1602 ( gen 3 I think, LED screen instead of the dials ) with no luck. Have 6 channels plugged in, proved that the lights work, but when i test with the HU the lights don't react. I had tried to run this controller as a standalone unit during halloween with no luck so there might be a sequence on it. When I try to remove the sequence from it using the HU I get an error message. Is there a way to just reset the controller and reassign ID to it? The manual only seems to cover the older unit with the dials. Thank you for reading this... Link to comment Share on other sites More sharing options...
Don Posted November 5, 2014 Share Posted November 5, 2014 See page 28 of the manual. Make sure you are reading the one for the 1602Wg3 controller. Here is a link. Link to comment Share on other sites More sharing options...
oilmoney Posted November 5, 2014 Author Share Posted November 5, 2014 Thank you! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now