CCR tree with San 682 problems

[boisechris]

Hi PPl

 

I'm hoping someone can help me out with my problem.

I just built my 12 ccr tree this weekend and tried a sequence tonight, which didn't work quite right.

The animation/morphs etc were not all in the right places. I'm using a Sandevice 692 Pixel 1 system which was already put together.

I think that possibly my E682 isn't configured right for my sequences or visa versa.....

 

Any help will be much appreciated.

I am including a picture of the san controller setup page. If I need to send one of my sequences we can exchange emails.

 

chris_stratis@live.com

 

Regards,

Chris 

 

[Ron Boyd]

Your Clusters look like this:

 

1-1 to 1-4--> Universe 1 channel 1  -------Universe 2 channel 90

2-1 to 2-4--> Universe 2 channel 1  -------Universe 3 channel 90

3-1 to 3-4--> Universe 3 channel 1  -------Universe 4 channel 90

 

You're overlapping your Universes and channels. It should be set up as the following:

 

1-1 to 1-4--> Universe 1 channel 1  -------Universe 2 channel 90

2-1 to 2-4--> Universe 2 channel 91-------Universe 3 channel 30

3-1 to 3-4--> Universe 3 channel 31-------Universe 4 channel 120

 

That takes care of the 12 strings.

 

Cluster 4-1 to 4-2, I assume would be used for something else. If that's the case, it should start at "Universe 4 channel 121" or "Universe 5 channel 1" depending on how you are using cluster 4.

[boisechris]

Thanks so much Ron!

Yeah...that makes sense. Wow..I was getting all kinds of crazy stuff on the Sequence.

I'm at work right now, but after I get home and connect to the e682 and change those settings, I assume that I press the update button on the far right for the changes to take effect?

I really appreciate the help Ron!  I've seen you in the forums helping so many people figure all this crazy stuff out, and we as a community very much appreciate people like you.

 

Best,

Chris