Jump to content
Light-O-Rama Forums

Sequence all programed but no lights


mlindell

Recommended Posts

Programmed all the sequence, added to show, set time. Time comes and no lights. Using unit 1 as CTB16D, unit 2 and unit 3 are CTB16PC. Can see and test lights with hardware utility, no problem. Just used CTB16D last year with no problem. I am using version 1.6.1 software. I've tried resetting unit ID's. I'm sure I'm missing something simple. I'm just lost. any ideas.

Link to comment
Share on other sites

Guest wbottomley

mlindell wrote:

Programmed all the sequence, added to show, set time. Time comes and no lights. Using unit 1 as CTB16D, unit 2 and unit 3 are CTB16PC. Can see and test lights with hardware utility, no problem. Just used CTB16D last year with no problem. I am using version 1.6.1 software. I've tried resetting unit ID's. I'm sure I'm missing something simple. I'm just lost. any ideas.


Have you configured your channels?

Check the data cable?

Fuses Blown?

GFCI's tripped?
Link to comment
Share on other sites

Mountainwxman wrote:

Have you configured your channels?

Check the data cable?

Fuses Blown?

GFCI's tripped?


He said things work with the HWU, so the only one of those that really applies is "Have you configured your channels" (assuming something didn't change since the HWU worked).

Also check your LOR network settings in the sequence editor.

-Tim
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...