Running CTB16Kpcv1 in DMX mode

[Tim Benson]

Hi,

 

I have a CTB16Kpcv1, well actually I have a lot of them.  Running V4.23 firmware.

 

Been using them for many years in a normal LOR network.

 

It seems to me that this should support DMX control.  Am I correct in this ?

 

LOR-3.11.2

I set up the  USB-RS485-B  Adapter as Universe in the network config.

The controller was address 0E, which should be DMX channels 209-224

Changed the sequence to address the channels Universe 1, 209-224

 

No Joy

 

I have lots of other DMX stuff running just fine. (Sandevices, Holiday Coro, DIYLED)

 

 

Did I miss something here, or is this controller too old ?

 

Tim

[Tim Benson]

Grrrrrr.  Nevermind.  It works if the cable is properly connected.