tjmarty Posted November 15, 2007 Share Posted November 15, 2007 All the channels work great but # 11 dos'nt do anything did check the power cord and is good just put this kit togather, any ideas. Link to comment Share on other sites More sharing options...
Guest wbottomley Posted November 15, 2007 Share Posted November 15, 2007 tjmarty wrote: All the channels work great but # 11 dos'nt do anything did check the power cord and is good just put this kit togather, any ideas.Start here first: http://www.lightorama.com/Documents/Kit_Troubleshooting_Guide.pdf Link to comment Share on other sites More sharing options...
tjmarty Posted November 15, 2007 Author Share Posted November 15, 2007 I did and ther is nother about channels not working Link to comment Share on other sites More sharing options...
fire_paramedic Posted November 15, 2007 Share Posted November 15, 2007 Check all your connections for the channel affected, check all solder points make sure they flowed well and that there are no (dull looking joints) cold solder joints, and no solder bridges. Check orientation of components also. first place to start. if all else fails reflow the joints on that channel to be sure.edited for stupid typing mistakes. Link to comment Share on other sites More sharing options...
Guest wbottomley Posted November 15, 2007 Share Posted November 15, 2007 tjmarty wrote: I did and ther is nother about channels not workingI know in the DIY thread there's some that talk about checking voltage on certain things. Scan through and see if your values match those posted there. Link to comment Share on other sites More sharing options...
tjmarty Posted November 15, 2007 Author Share Posted November 15, 2007 Mountainwxman wrote: tjmarty wrote: All the channels work great but # 11 dos'nt do anything did check the power cord and is good just put this kit togather, any ideas.Start here first: http://www.lightorama.com/Documents/Kit_Troubleshooting_Guide.pdfokay thanks Link to comment Share on other sites More sharing options...
tjmarty Posted November 16, 2007 Author Share Posted November 16, 2007 tjmarty wrote: All the channels work great but # 11 dos'nt do anything did check the power cord and is good just put this kit togather, any ideas.I found the Problem IC chip was in the wrong way Thanks for all your help Link to comment Share on other sites More sharing options...
Recommended Posts