Jump to content
Light-O-Rama Forums

RGB-Ribbon-150


USCS31

Recommended Posts

Hello! I know this is labeled CCD's but I wasnt sure if I could post this here! I was looking to purchase LOR 8 pack RGB-Ribbon-150 for around $500. My question is this: is there a way to cut these (for around windows, doors, etc...) and link the cut areas back together to make it one piece again? I saw on some other websites where they were selling an "L" shaped item (looked like the inside of the strip) and you could use that to link the sides together again. Does LOR RGB Ribbons have anything like that? Thanks USCS31

Link to comment
Share on other sites

The solder less connectors are junk, especially if your in a cold weather climate.  Yes they can be cut and patched together again.

  • Like 1
Link to comment
Share on other sites

I agree with the above - hard-soldering them is best (with short little jumper wires).  I use a flux pen and the solder flows right on the little pads.  The bigger trick is making sure everything stays sealed/weatherproof.

  • Like 1
Link to comment
Share on other sites

  • The topic was locked
Guest
This topic is now closed to further replies.
×
×
  • Create New...