mrduncan Posted December 19, 2013 Share Posted December 19, 2013 I just has one of my CTB16PCG2 totally go dead....no blinking green light. Fuses check out OK. Any other ideas where to look for the problem? Thanks in advance.....Mike Link to comment Share on other sites More sharing options...
dslowik Posted December 19, 2013 Share Posted December 19, 2013 Verify the board is getting power from the supply cords. I just has one of my CTB16PCG2 totally go dead....no blinking green light. Fuses check out OK. Any other ideas where to look for the problem? Thanks in advance.....Mike Link to comment Share on other sites More sharing options...
dslowik Posted December 19, 2013 Share Posted December 19, 2013 Also, even though you checked the fuses, swap the left and right fuse to see if the led starts blinking. Link to comment Share on other sites More sharing options...
mrduncan Posted December 19, 2013 Author Share Posted December 19, 2013 I knew I liked LOR products........messed with the unit for about an hour, checking the fuses, checking power on the down side of the fuse, plugging the unit in multiple time, and all the sudden......the LED started blinking. Gen 2 must have self-healing PC boards and components. This all started when I tried to plug a LOR DC controller card in-line at the suspect LOR CB16......makes you want to say HUMMMMM..... Link to comment Share on other sites More sharing options...
Recommended Posts