doubleeaz Posted November 30, 2013 Share Posted November 30, 2013 I read in the user's guide that a servodog should work with DMX input. However, when I run DMX into it, it does not output correctly. If I use the LOR USB dongle it works fine. I have the latest firmware and checked that it is configured properly for my application, which is all digital outputs. I output a 8-bit code using 8 channels which tells me which song is being played. Any ideas? i have tried to different DMX sources. Thanks in advance for any suggestions. Link to comment Share on other sites More sharing options...
Randy Posted December 15, 2013 Share Posted December 15, 2013 Are you using the DMX table at the back of the Servodog user manual to set up your addressing? Link to comment Share on other sites More sharing options...
Recommended Posts