T17443 Posted October 12, 2013 Share Posted October 12, 2013 I am trying to configure my new CCFs using a CMB24D card. They work fine in test mode using the hardware utility. When I try to control them using the sequence editor I get no response. I have tried to set up as an normal Light O Rama controller and as RGB channels, not luck. I obviously have something configured wrong. Any ideas. Link to comment Share on other sites More sharing options...
htebault Posted October 12, 2013 Share Posted October 12, 2013 I have a CMD24D card - My channel config shows it as a Device Type Light-O-Rama Controller. I have it set to Unit 04 - and each color is a different circuit - So the first RGB ribbon is Red/04.01, Green/04.02/Blue/04.03 - ensure you have "control lights" enabled in PLAY, just in case.Have you set up teh visualizer to show them yet? If you have, that is another way to verify if it is working. Link to comment Share on other sites More sharing options...
Recommended Posts