stachows Posted October 5, 2013 Share Posted October 5, 2013 When I run my LOR network at 500K my CTB16PC stop responding. Do they not respond at this speed? Do I need to put them on a separate slower network? If I slow the network speed back down they start working again, but my CCB's can't keep up (look like garbage). When I speed it up, the CCB's look fine, but the CTB16PC's stop responding. Thanks,Scott. Link to comment Share on other sites More sharing options...
Don Posted October 5, 2013 Share Posted October 5, 2013 v4.32 is a firmware version for an older non-G3 controller. At this time the G3 controllers are the only ones that support 500k. I don't know if there will be a firmware update that will allow them to do so, or if it's even possible. You'll need to run the CCB's on their own network if you want to run them at 500k. Link to comment Share on other sites More sharing options...
stachows Posted October 7, 2013 Author Share Posted October 7, 2013 That's what I thought, (and am currently doing)... Thanks for the update. Do the older CCR's run at 500K as well? I have not tried yet, just wondering anyone knows? Link to comment Share on other sites More sharing options...
pyromill Posted October 9, 2013 Share Posted October 9, 2013 Not looking at the spec sheet on the rs485 chip in my controllers.. Did it change in the g3 controllers? Link to comment Share on other sites More sharing options...
Dad02 Posted October 14, 2013 Share Posted October 14, 2013 (edited) How about a CTB16D w/ V4.01, is it upgradable to 500K? Edited October 14, 2013 by BrianC Link to comment Share on other sites More sharing options...
Recommended Posts