Jump to content
Light-O-Rama Forums

X10 ok in hardware utility - not in sequence


khays

Recommended Posts

I have a new CM11A and some appliance modules. I can operate the modules with no problem using the hardware utiliy. When I set a sequence channel to use X10 unit ID it is not working. I have set the network settings in the sequence editor to the same serial port as tested in the hardware util. Anyone see what I'm missing.

Link to comment
Share on other sites

My first thought is that you com port is locked up. I would do a restart and retry it. I have noticed that the cm11a some time can lock up the com port when you go from one program to the next.

Link to comment
Share on other sites

It does sound like an issue with the port. Make sure that the Hardware Utility is not running when you run the sequence editor.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...