ed26105 Posted July 20, 2013 Share Posted July 20, 2013 I am testing newly purchased CCPixels. I have set up one controller as unit 10, LOR regular device. I updated the firmware. When I run a test sequence, channel 13, 14 and 15 on unit 11 cause lights on unit 10 to operate. I can figure this out. If I change unit 11 channel to unit 12, it stops. But somehow it looks like units 10 and 11 are crossed. I checked channel configuration and there are no overlaps. Any ideas? Link to comment Share on other sites More sharing options...
k6ccc Posted July 20, 2013 Share Posted July 20, 2013 Make sure you the unit configured as 10 is not in legacy mode. Link to comment Share on other sites More sharing options...
Recommended Posts