viennaxmas Posted June 28, 2013 Share Posted June 28, 2013 I did run in an interesting issue with the sequencer today (and after a few hours of searching found the solution): When starting playback of a sequence, there was a delay of up to five seconds before playback started. Using teh space bar to start/stop a sequence also was between 3 and 10 seconds delayed. In addition, playing a sequence "stuttered" as soon as I turned on more than 20 lights at the same time. This happend with both, Musical and Animation sequences. Drove me nuts. After some serious searching, I found that last year at some point, I had changed the IP address for the Visualizer and S3 was constantly trying to send data to a "non existing Visualizer". As soon as I changed the IP back to 127.0.0.1 - everything worked fine again... Just in case someone else runs into the same issue. P.S. happend on 3.9 and 3.10.2 Beta. Not sure if it is possible to add a check when launching the sequencer... could have saved me some grey hair Link to comment Share on other sites More sharing options...
Recommended Posts