craig115 Posted December 4, 2012 Share Posted December 4, 2012 Hi I just purchased the 1602Wg3. I want to hook up three switches to the 10 pin port however am not sure of the best method to do this. Are there any connectors available for this. I didn't see anything on the LOR sight or documentation on how to make the connections. I didn't want to just stuff my wires into the availabel pin holes.Thanks...Craig Link to comment Share on other sites More sharing options...
TitusCarnathan Posted December 5, 2012 Share Posted December 5, 2012 for the older controllers they made a connector to make it easier I am not sure if there is any update on the release of the new connector or not but you could get a connector on mouser.com I believe this would be what you need http://www.mouser.com/ProductDetail/TE-Connectivity/87077-2/?qs=%2fha2pyFaduhjUcjf80d2VdOaHrvVfRTDbKJdUwmwiSo%3d Link to comment Share on other sites More sharing options...
TitusCarnathan Posted December 5, 2012 Share Posted December 5, 2012 (edited) the wiring diagram is http://www.lightoram...UserMan_Web.pdfon page 28 or PDF page 14 you would basically have Input 1 going to the switch and the other side going to Ground doing the same for Input 2 and 3 where they would feed to ground Edited December 5, 2012 by TitusCarnathan Link to comment Share on other sites More sharing options...
Recommended Posts