Travis M Roberts33 Posted September 4, 2012 Share Posted September 4, 2012 I set up a simple show to run and test with new built PC kits. Started show and it will play each song for 5sec and go to next song. Then it will stop music but show is still enabled. Songs will play in sequence editor with no problem with test lights firing. Tried to upgrade to newest level and didn't help problem. I did a help ticket today and they had me check the song Bit rate. I found a sequence with audio at 128k and same issue. Anyone seen this I'm a new user? Link to comment Share on other sites More sharing options...
Guest wbottomley Posted September 6, 2012 Share Posted September 6, 2012 What does your control panel log say when that happens as you described?Please post those results here. Link to comment Share on other sites More sharing options...
LOR Staff Posted September 6, 2012 Share Posted September 6, 2012 This is a line from his log. I'm waiting on him to attach the LMS so I can trace it through the show runner, but if anyone has any ideas please let me know! I'm not an expert (or even novice) when it comes to running shows, so I have to pick through the code by hand....6:54:23 PM: ERROR WITH SEQUENCE (Address in useTrace: UDP SetIntensityTrace: HandleIO) Musical: C:\Users\Jessica\Documents\Light-O-Rama\Sequences\2012 Christmas Canon Rock.lms.lcs Link to comment Share on other sites More sharing options...
Guest wbottomley Posted September 6, 2012 Share Posted September 6, 2012 I would try remapping the audio file and save once again. Link to comment Share on other sites More sharing options...
Jim Hans Posted September 6, 2012 Share Posted September 6, 2012 Sometimes the obvious can help. Have you tried rebooting your computer? Link to comment Share on other sites More sharing options...
Recommended Posts