joshua Posted May 19, 2012 Share Posted May 19, 2012 Hello i am getting an open com port error when trying to control the lights via lynx dongle? just upgraded to newest version. Link to comment Share on other sites More sharing options...
joshua Posted May 19, 2012 Author Share Posted May 19, 2012 it says open of serial port has failed. i have tried unplugging the dongle? Link to comment Share on other sites More sharing options...
WilliamS Posted May 19, 2012 Share Posted May 19, 2012 Is the hardware wizard open at the same time?Did you check the hardware wizard to make sure the settings are still in there? Link to comment Share on other sites More sharing options...
bisquit476 Posted May 19, 2012 Share Posted May 19, 2012 What version of the software are you running? You need the advanced to work with DMX. Link to comment Share on other sites More sharing options...
joshua Posted May 19, 2012 Author Share Posted May 19, 2012 Newest version of software advanced. Worked lastyear. Has hap po end since upgrade Link to comment Share on other sites More sharing options...
joshua Posted May 19, 2012 Author Share Posted May 19, 2012 Cant seem to find the listner? Whst do I need to do to set this up? Link to comment Share on other sites More sharing options...
JonB256 Posted May 19, 2012 Share Posted May 19, 2012 the most frequent fix has been a reinstall. Don't uninstall. Just install again. The Listener should auto start when you start the Control Panel (not just the sequencer) IF you have the Lynx dongle properly identified in the network settings. Link to comment Share on other sites More sharing options...
Recommended Posts