Worse than before the upgrade

[pyromill]

Is anyone else having problems with lockups... dmx failing daily?

[ItsMeBobO]

At one point I had a lot of lock ups which drove crazy. But I dont think its an S3 issue.
Tracked it down to a mistake on the SE network preferences. Had a network which did not exist. On the sequence which is locking, verify the config does not have any network which is not defined in preferences.

[LightORamaDan]

Are you seeing any log messages when the lock up happens (or perhaps the lockup prevents log messages). As far as I know there were no changes that should have affected DMX hanging.

[pyromill]

Bob I checked the network prefrences all those checked out good.

Dan errors are as follows

2012-03-28 15:58:19 3:Listener [ERROR] Socket 428, connection closed while r
eading msg header
2012-03-28 15:58:19 25:Listener [iNFO ] Socket 428, exiting
2012-03-28 16:30:00 16:DMX1 [ERROR] ENQ8N2SM: Cannot write ENTTEC header

I did think of one thing though and that was the power saving options. I checked that out and the computer never did go to sleep even though it was set to sleep after an hour. So that got changed to never sleep as an attempt to see if it might have been causing issues with the usb.

[bisquit476]

That last error is a half hour later, is the system running good until then?

[LightORamaDan]

pyromill wrote:

Bob I checked the network prefrences all those checked out good.

Dan errors are as follows

2012-03-28 15:58:19 3:Listener [ERROR] Socket 428, connection closed while r
eading msg header
2012-03-28 15:58:19 25:Listener [iNFO ] Socket 428, exiting
2012-03-28 16:30:00 16:DMX1 [ERROR] ENQ8N2SM: Cannot write ENTTEC header

I did think of one thing though and that was the power saving options. I checked that out and the computer never did go to sleep even though it was set to sleep after an hour. So that got changed to never sleep as an attempt to see if it might have been causing issues with the usb.

If that doesn't help please open a trouble ticket.

Thanks
Dan