edepinet Posted January 4, 2012 Share Posted January 4, 2012 I can't get Macro Maestro to work. I used it last year with no problems. This year it will not work. I have Superstar Sequence Editor, but I would like to mix them us some. I deleted my old macro maestro clipboard and replaced it. This will not work. Link to comment Share on other sites More sharing options...
Don Posted January 4, 2012 Share Posted January 4, 2012 Have you sent a PM to ItsMeBobO yet?Being that Macro Maestro is written by Bob, he might be your best resource. Link to comment Share on other sites More sharing options...
edepinet Posted January 4, 2012 Author Share Posted January 4, 2012 Thanks, will do. Link to comment Share on other sites More sharing options...
Rick Childers Posted January 4, 2012 Share Posted January 4, 2012 Where can I find "Macro Maestro" ? Link to comment Share on other sites More sharing options...
ItsMeBobO Posted January 4, 2012 Share Posted January 4, 2012 The most common oversight is leaving the color off. MM just does the macro part. You must enter the color in RGB 1.MacroMaestro can be found on my software page in my Sig. Link to comment Share on other sites More sharing options...
edepinet Posted January 4, 2012 Author Share Posted January 4, 2012 here is an attacment that will not work. forgive the visualizer, I just wanted to see movement.Ed Attached files Chipmuck Christmas 2010.lms Link to comment Share on other sites More sharing options...
ItsMeBobO Posted January 4, 2012 Share Posted January 4, 2012 The macros in the first 5 seconds worked on my setup. That is after I fixed the mistake in your Config. RGB 1 is wrong.Reminder: The legacy animation in S2/S3 does not show CCR Macros at all. To see them you must either have the CCR hooked up and in your sight. Or you can draw a CCR in the new S3 visualizer. Link to comment Share on other sites More sharing options...
Recommended Posts