tjmarty Posted December 20, 2011 Share Posted December 20, 2011 One channel is staying lit at about 50%. just started 3 days ago this is the second season for that controller the other controllers and channels are working just fine, stays on even after the computer is turned off. Link to comment Share on other sites More sharing options...
Guest guest Posted December 20, 2011 Share Posted December 20, 2011 have you tried a reset? refer to the attached doc. Attached files Kit_Troubleshooting_Guide.pdf Link to comment Share on other sites More sharing options...
tjmarty Posted December 20, 2011 Author Share Posted December 20, 2011 No i haven't but i will do that tomorrow be for the show starts, thank you. I would do it now but it is raining. Link to comment Share on other sites More sharing options...
grandlakedad Posted December 20, 2011 Share Posted December 20, 2011 Also look under the LOR DIY link then the 2 channels stuck on thread. Link to comment Share on other sites More sharing options...
tjmarty Posted December 21, 2011 Author Share Posted December 21, 2011 I did read that thread thank you it seems to be the MOC Or what i call the white IC chips. Did a reset and still same problem. Link to comment Share on other sites More sharing options...
Guest guest Posted December 21, 2011 Share Posted December 21, 2011 would doubt it is the opto..more likely a triac....the optos are pretty low failure rate. Link to comment Share on other sites More sharing options...
Recommended Posts