doogy_7 Posted December 11, 2011 Share Posted December 11, 2011 8 channels of my mega tree went out.....found one of the output wires to the tree had a bare spot of insulation touching a metal support....ughhh..........assumed i pooped the fuse to channels 9-16 so I fixed the wire, replaced the fuse and still not working.....what should I check or do now??? Link to comment Share on other sites More sharing options...
james campbell Posted December 11, 2011 Share Posted December 11, 2011 did you check the breaker or gfci? if that is ok try doing a controller reset Link to comment Share on other sites More sharing options...
doogy_7 Posted December 11, 2011 Author Share Posted December 11, 2011 breaker is fine.....im thinking ill swap the controller out and bring it inside.....I am lucky enough to have a new (spare) controller.....Still would like to figure this one out though Link to comment Share on other sites More sharing options...
doogy_7 Posted December 11, 2011 Author Share Posted December 11, 2011 Ha i feel stupid.............might help if i change the fuse on 1-8 not 9-16....duhhh Link to comment Share on other sites More sharing options...
cmoore60 Posted December 11, 2011 Share Posted December 11, 2011 I was going to chime in. If the fuse on 9-16 went bad the entire controller will not work. The 9-16 side provides power to run the electronics.Glad you figured it out.Chuck Link to comment Share on other sites More sharing options...
CKSedg Posted December 11, 2011 Share Posted December 11, 2011 doogy_7 wrote: assumed i pooped the fuse...You did WHAT to the fuse? Link to comment Share on other sites More sharing options...
WilliamS Posted December 12, 2011 Share Posted December 12, 2011 FAIL! Its ok I would have made the same mistake! Probably would have booted the controller across the yard, hit with shovel, peed a bit on it, then would have read this and been MAD. Glad its working and send that spare here, I need it! Link to comment Share on other sites More sharing options...
Recommended Posts