juxtapoz15 Posted November 21, 2011 Share Posted November 21, 2011 So I am really really new to this. I have my controller up and running and the lights work fine on the Hardware Utility. The Comm port is on channel 5 the unit ID is 01. I created a few sequences in SE, but when I play them nothing will light up. I did try the "Control Lights" option under the play menu in SE. I also checked in network preferences and the network is set to Regular and the port is set to Comm 5.In the LOR status window it says that LOR 3.0.2 is disabled.Am I missing something?? Should I be able to see lights changing when playing back sequences in SE? Thanks!! Link to comment Share on other sites More sharing options...
cmoore60 Posted November 21, 2011 Share Posted November 21, 2011 You can only have ONE of the following running at one time.Sequence editor, Hardware utility or the control panel with shows enabled.Only one of them can control the comms at one time. Sounds like you MIGHT have the HWU open while trying to play the sequence from the sequence editor.Chuck Link to comment Share on other sites More sharing options...
juxtapoz15 Posted November 22, 2011 Author Share Posted November 22, 2011 Thanks, this ended up resolving my problem. I did try that earlier in the night but the controller would give me a flashing red LED when the hardware utility was not up. I ended up restarting the software and everything is working fine now. Link to comment Share on other sites More sharing options...
Recommended Posts