Jump to content
Light-O-Rama Forums

DC board doesnt save unit ID


Recommended Posts

vincerules wrote:

I have a DC board with the quick disconnects, when I change its unit id to 5 in hardware utility, it works fine, but then when I power it down it loses its id.

You do not set the unit ID in the hardware utility with this board.

Use the dials on the board only. Then the ID settings will be saved.
Link to comment
Share on other sites

  • 2 weeks later...

Was the power OFF when you set the dials ?

If so, try this. Remove power from the board adain. Spin each dial all the way around at least twice, then reset to unit 05. (sometimes the dial contacts will oxidise a little)

Reapply power and recheck in the HWU.

Link to comment
Share on other sites

This topic is now closed to further replies.
  • Create New...