goduke21 Posted November 14, 2011 Share Posted November 14, 2011 I know I'm missing something simple but where do I go in the HU to see if all my controllers are daisy chained together properly. I know how to check one controller but how do I make sure my network sees all my controllers. Link to comment Share on other sites More sharing options...
Greg Posted November 14, 2011 Share Posted November 14, 2011 In HU make sre your Mas unit id number is equal to or higher than your number of controllers hooked up. The click the refresh button in the drop down window to the right you should see all your controllers after the refresh finishes. lso make sure you are set on the correct comm port Link to comment Share on other sites More sharing options...
goduke21 Posted November 14, 2011 Author Share Posted November 14, 2011 Thanks Link to comment Share on other sites More sharing options...
Recommended Posts