countrywise Posted November 13, 2011 Share Posted November 13, 2011 Has anyone experienced issues while sending DMX intensity values from LOR S3 to Madrix (or any other software)? My configuration consists of LOR S3, Madrix, and two Enttec USB Pros. I use one box as output for LOR and the other as input for Madrix. I have had them talking to each other a few times and thought all was well, but for some reason, either LOR quits sending or Madrix quits receiving. Have tried to unload the devices from both software and reload. No response. LOR DMX listener port says the Enttec device is found and appears to be ready. Madrix DMX input device shows as the other Enttec box correctly but the DMX watcher program doesn't receive any codes when sending from LOR. Have also tried the sequence of loading LOR first and Madrix second and vice versa with no positive results. Am I making this too hard and overlooking the obvious???? Any suggestions would be greatly appreciated!!! Link to comment Share on other sites More sharing options...
Recommended Posts