bretk Posted November 2, 2011 Share Posted November 2, 2011 ok, so i just got my 2 ccrs today and set up a new sequence with ccr 1 set as controller 6 and ccr 2 set as controller 7. added them to the sequence after assigning ids in the hardware editor. using the add device right click. if i run just one device it works fine, but if i add a second device to the sequence and run anything on it i get a jumbled ghost image on ccr 1 as well as the correct image on ccr 2.what am i doing wrong, or is it the controllersthanks, bret Link to comment Share on other sites More sharing options...
Jay Czerwinski Posted November 3, 2011 Share Posted November 3, 2011 I believe I am getting the same problem. And it continues if I add a third, then the first two are jumbled. And when I add a fourth, the first three are jumbled....I'll keep an eye out here too, but if I find a solution for my problem I'll post the suggestion here.Jay Link to comment Share on other sites More sharing options...
DanR Posted November 4, 2011 Share Posted November 4, 2011 When you setup the CCR did you set the Unit ID Mode to 'Normal'?Dan Attached files Link to comment Share on other sites More sharing options...
Jay Czerwinski Posted November 4, 2011 Share Posted November 4, 2011 Wow..... What I would have paid to have that info just moments before my party last weekend.Although it took me a second to find that menu in the hardware utility, just a couple of simple clicks and the problem was solved......Thank you. Link to comment Share on other sites More sharing options...
DanR Posted November 4, 2011 Share Posted November 4, 2011 The same thing happened to me. Quite a mosaic of colored LEDs! Link to comment Share on other sites More sharing options...
steve synek Posted November 24, 2011 Share Posted November 24, 2011 Thank you, thank you , thank you!!!! The information to be found here is tremendous if you can take the time to find it. The time I spent hunting for the cause could have been better spent here reading.http://forums.lightorama.com/forum95/30088.htmlSteve Link to comment Share on other sites More sharing options...
Recommended Posts