Sequencer Crashes when changing Visualizer Output Port number

[heystew]

The S3 sequencer crashes when i enter a high port number on the Visualizer Preferences of the sequencer. Any number higher than 32767 will cause a crash. I have no need to go that high, but the Visualizer config says it can use the range of 0-65535 so I figure it shouldn't crash.

I only tried it because I was toying around to see if i could send it to a multicast address. (would help if i could run multiple visualizers to help with running into size limits on visualizer configs).

[LOR Staff]

Even if you set it to a multicast address, it won't actually DO the multi-casting. Someone in the beta test ran a program that would re-broadcast the packets to 2 or more computers, but that isn't supported.

I'll make sure we look at that crash however. That shouldn't be happening.

[bob]

This will be fixed in the next release. Thanks for pointing it out.