Deck Posted September 27, 2011 Posted September 27, 2011 Not sure if this will make any sense. I have 1 16 channel lor, and 2 ccr’s, I set the units to 01(lor), 02(ccr) and 03(ccr). I do not use any tracks for my sequence. I made my 16 channels and then added the 2 ccr’s channels. The two ccr’s are made into 4 arches. When I sequence the first set of ccr’s, to say chase red, no problem, they go back and forth in red. When I added the same type of chase to the second ccr, the first ccr’s lights start to act up and the colors are not all the same. This is all new to me, hope this does not sound too crazy...any suggestions?
CLD Kevin Posted September 28, 2011 Posted September 28, 2011 Try resetting the CCR....actual reset both. To do this, hold the reset button while powering on the controller. Keep holding the button and the CCR will quicky go through the 3 colors over and over. Just hold it for a few seconds. Reset is done. Now run your seq again.I had this same problem with every CCR.
Deck Posted September 28, 2011 Author Posted September 28, 2011 Cracker;Thanks for the help and quick response.....It ended up being very simple.....was set in Legacy.......made the change and all is working.....
Recommended Posts