maxall777 Posted July 28, 2013 Share Posted July 28, 2013 Hi I am trying to setup 2 networks 1 DMX the other LOR. I am using 2 of the USB 485 LOR adapters. I have the adapters setup in network preferences. I am trying to run a holiday coro RGB decoder when I start the sequence the RGB lights flicker on and of randomly as the sequence runs. Does anyone have any ideas or the same problem? Link to comment Share on other sites More sharing options...
Dennis Laff Posted July 28, 2013 Share Posted July 28, 2013 Check the holiday coro website I think you might need a crossover cable ( sold at holiday coro )to use the lor usb 45 with dmx Link to comment Share on other sites More sharing options...
maxall777 Posted July 28, 2013 Author Share Posted July 28, 2013 I have the cross over cable . It was working but then it started the flickering . Link to comment Share on other sites More sharing options...
Dennis Laff Posted July 28, 2013 Share Posted July 28, 2013 I had similar problem with lor dongle so I bought the Holiday coro actidongle and then it worked fine Link to comment Share on other sites More sharing options...
Ken Benedict Posted July 31, 2013 Share Posted July 31, 2013 LOR says the USB 485 adapters can run DMX: http://forums.lightorama.com/index.php?/topic/27415-dmx-adaptor-in-lor-network-preferences/?p=258348 Link to comment Share on other sites More sharing options...
dmoore Posted August 12, 2013 Share Posted August 12, 2013 Bob - Contact us over at HolidayCoro and we'll be happy to assit you in finding a solution to your issue. Thanks,DavidHolidaycoro Link to comment Share on other sites More sharing options...
daveo150 Posted August 23, 2013 Share Posted August 23, 2013 max, I had the same problem last year....start at square 1. with no dmx signal, do your lights run the test sequence correctly? if yes, try to control them with xlights. if they don't work there, the problem is your dmx signal. in my case, I had a bad solder joint on the dmx- wire and it caused random flickering the whole sequence. Link to comment Share on other sites More sharing options...
Ken Benedict Posted August 23, 2013 Share Posted August 23, 2013 (edited) (bad post) Edited August 23, 2013 by Ken Benedict Link to comment Share on other sites More sharing options...
Recommended Posts