Guest guest Posted September 1, 2006 Posted September 1, 2006 When I hit the refresh button on the hardware utility menu, the scan seems to take a very long time (5-10 minutes). This occurs with only a single LOR board connected. Is this normal? I tried disabling my wireless network card, thinking it was searching all "Networks", but it didn't made a difference.Why does this take so long?
Guest guest Posted September 1, 2006 Posted September 1, 2006 In the LOR tab of the Hardware utility, what do you have the maximum units set to?Unless you have a lot of channels, you don't need it any higher than 10. (Which is the lowest it will go.)
Recommended Posts