ndiaz Posted December 6, 2009 Share Posted December 6, 2009 So, I've built the panels and have 2 sequences ready.What I've done:Connect triggers to board,Move Jumper,put animation sequence into the show,put interactive sequences on separate Trigger groupsAnd it isn't working...The animation plays, but when a trigger is closed, nothing happens. The sequences all work with the lights, but not with the trigger.I'm using a PC board, Do I need to update firmware?If anyone can help, I'd appreciate it.Nick Link to comment Share on other sites More sharing options...
-klb- Posted December 6, 2009 Share Posted December 6, 2009 You need at least 4.30 firmware. Link to comment Share on other sites More sharing options...
ndiaz Posted December 7, 2009 Author Share Posted December 7, 2009 Thanks guys, I'll update it when I get home. Link to comment Share on other sites More sharing options...
ndiaz Posted December 7, 2009 Author Share Posted December 7, 2009 Thanks Guys! The trigger Sequences work, and My lights are on now.There is still a small problem though... because I have an all-on animation, when the lights are on, any circuit not used will turn on, and then It'll get a command, but will go back to being at the on state.Any advice? Link to comment Share on other sites More sharing options...
Recommended Posts