Guest Don Gillespie Posted November 21, 2009 Share Posted November 21, 2009 I thought I blew a fuse and after checking this as not the case I changed my extension cords to 12-3 the other three banks are working but one of them is not the power is good the gfi has not tripped any ideas as to why it is only doing this on one bank I have the LOR1602W system 32 banks what else can I check, I have tried different plugs but still no response if this helps I just tried each bank from my garage which is 15 amps nothing tripped so I know for certain my amps are all ok is it possible it is a bad controller? Link to comment Share on other sites More sharing options...
Darryl Lambert Posted November 21, 2009 Share Posted November 21, 2009 A few questions to clarifyAre all 8 channels out ie.1-8 or 9-16How did you check the fuse? Try to swap fuses (left for right ,& right for left) in the same controler.Did you try to swap the extention cords where they plug into the controller (only there not on the receptacle end)?In each of these cases the same bank of channels should be out.Also you might want to check your channel property grid in the sequence just to make sure they are assigned properly.Hopefully this might help narrow it down.Darryl Link to comment Share on other sites More sharing options...
Recommended Posts