Guest guest Posted July 5, 2006 Share Posted July 5, 2006 Greetings.I received my two new units today. Hooked one up and proceed to use comm2. After changing this in the hardware utility and watch all the twinkles, chases, and fades work, I closed the utility.The question I have is I had to change to comm2 again and refresh to make it work again. Is there a way to have comm2 saved as the default? Link to comment Share on other sites More sharing options...
Guest guest Posted July 5, 2006 Share Posted July 5, 2006 Ok well, I am not looking at the hardware utility right now. But I think when you change the port (Comm #) It should ask you somthing like is this the port you want to use for the shows and you would hit yes, Then it say somthing like LOR has been set to port whatever you set. Remember that I am not looking at the Hardware utility so correct me if I am wrong.Hope this helps, and I understanded your question right.Richard Link to comment Share on other sites More sharing options...
Recommended Posts