rdebolt Posted October 10, 2009 Posted October 10, 2009 I just installed version 2.4.10. In the hardware utility I can control my lights, but when I play my sequence or run a show my lights do not work. Is there a new setting that I am missing somewhere? I checked in my sequences and the channel configuration looks ok to me. Thanks in advance!
cmoore60 Posted October 10, 2009 Posted October 10, 2009 Check to make sure that your sequence editor is using hte same com port as your hardware utility.Chuck
rdebolt Posted October 10, 2009 Author Posted October 10, 2009 I have done that and it is running the same com port.
cmoore60 Posted October 10, 2009 Posted October 10, 2009 is enabled lights checked in the sequence editor?What is the status of the LED on the controller when the sequence editor is open?Long shot. Did you configure your rows to controller unit and channels?Chuck
rdebolt Posted October 10, 2009 Author Posted October 10, 2009 Yes enabled lights are checked.Yes the rows are configured, I even changed them with no results.I have not checked the LED on the controller, but if they work through the hardware utility, I would think that I have at least some communication. I will go pull the cver and see. Thanks for the help!
cmoore60 Posted October 10, 2009 Posted October 10, 2009 What address did you set your controllers to?Chuck
rdebolt Posted October 10, 2009 Author Posted October 10, 2009 OK I just switched everything over to my laptop running version 2.3.6 and everything runs fine. Maybe I should uninstall the software and reinstall.
Recommended Posts