Danbel Posted December 25, 2008 Posted December 25, 2008 I buy 2 more CTB16pcv How I have 5 unite .My first unite I solder them they working very good .My last two i order I didn't have time to weld them One my friend solder them .One my unite is not working .I connect my unite light flash (NORMAL)Open LOR hardware light STOP flashing (normal) But on this unite when press refresh say(unable to locate addressee) I try SET UNITE ID same thing Try change Existing ID same thingWent I connect another unite they work well 'So is not my USB port or my usb 485something wrong with board or ic or Dip I can't connect to my network (I thing)I check all the solder for coldwell everything look okDaniel
cmoore60 Posted December 25, 2008 Posted December 25, 2008 Do you have the max unit set high enough to allow the HWU to find the new address?
Danbel Posted December 25, 2008 Author Posted December 25, 2008 YES I have Max id to maxThankHappy Holiday
Guest wbottomley Posted December 26, 2008 Posted December 26, 2008 Check to see if your comm chip was placed in correctly.
Danbel Posted December 26, 2008 Author Posted December 26, 2008 Mountainwxman wrote: Check to see if your comm chip was placed in correctly.I double and double check all my network resistor ,all good placeThank DanielHappy Holidays
Danbel Posted December 26, 2008 Author Posted December 26, 2008 cmoore60 wrote: Did this controller work before?ChuckFirst time I try last two My friend just finish solder them last week.Daniel
Danbel Posted December 29, 2008 Author Posted December 29, 2008 cmoore60 wrote: Did this controller work before?ChuckFirst time I try last two My friend just finish solder them last week.Daniel
Recommended Posts