Cathy D. Posted December 6, 2008 Share Posted December 6, 2008 How do I put all the lights on w/out running the show? Link to comment Share on other sites More sharing options...
pdowns Posted December 6, 2008 Share Posted December 6, 2008 I have found that there are times when I want to see everything on at once and this is not what happens in any of the sequences I use in my show.If you only have one controller you can use the hardware utility to turn everything on at once.If you have more than one controller (I have 3) you will have to create an animation sequence that turns everything on. It only took me a few minutes to create this. Use loops to easily extend the time of the sequence to suit your needs. Link to comment Share on other sites More sharing options...
Cathy D. Posted December 6, 2008 Author Share Posted December 6, 2008 thank you Link to comment Share on other sites More sharing options...
Dennis Cherry Posted December 7, 2008 Share Posted December 7, 2008 I believe you can use the Hardware utility and after finding all the controllers select the first controller then do a ON, then select the next controller and do another ON, do this for all controllers.To turn everything OFF you have to reverse the procedure or just disconnect the Cat5 cable, in a couple of seconds the light will go off but you lose the ID's in the HU. Link to comment Share on other sites More sharing options...
Recommended Posts