Alpha pix S6 Setup

[Bumble]

Hello all,

I am setting up a new alpha pix e1.31 controller.  This is the first one I have set up in S6.  In S5 there was a "LOR advanced network preferences tab" where you could assign IP addresses to universes.  Where is this done in S6?

My controller shows up in the new control panel but I get no lights on.  Test patterns run from the controller and alphapix software work fine.  My othe alpha pix controllers are running fine in S6.

[ebrown1972]

52 minutes ago, Bumble said:

Hello all,

I am setting up a new alpha pix e1.31 controller.  This is the first one I have set up in S6.  In S5 there was a "LOR advanced network preferences tab" where you could assign IP addresses to universes.  Where is this done in S6?

My controller shows up in the new control panel but I get no lights on.  Test patterns run from the controller and alphapix software work fine.  My othe alpha pix controllers are running fine in S6.

Open control panel and on the left hand side is a networks tab. Click it then at the top click add. Once you do that you can assign the IP addresses and set up the universes.