ksr Posted October 30, 2008 Share Posted October 30, 2008 Ok, I'm sure I'm missing something. Everything seems fine, but the lights do not come on. Utility found my controller, the sequence plays fine, everything seems to be hooked up--but no lights! I ran the test--no lights.thanksksr Link to comment Share on other sites More sharing options...
evan.a Posted October 30, 2008 Share Posted October 30, 2008 did you assasign each channels for unit id? Link to comment Share on other sites More sharing options...
ksr Posted October 30, 2008 Author Share Posted October 30, 2008 If you mean in the sequence editor--yes. If not the sequence editor--not sure. Link to comment Share on other sites More sharing options...
evan.a Posted October 30, 2008 Share Posted October 30, 2008 right click each channel. you must address every channel for unit id Link to comment Share on other sites More sharing options...
dodgertrue Posted October 30, 2008 Share Posted October 30, 2008 Did you Right click on the light bulb in the right hand tray and enable the show. Link to comment Share on other sites More sharing options...
ksr Posted October 30, 2008 Author Share Posted October 30, 2008 You're right--was set to unit 2--needed to be 1. I'm in business--my first show is running--amazing!!Thanks for the quick help!ksr Link to comment Share on other sites More sharing options...
evan.a Posted October 30, 2008 Share Posted October 30, 2008 what about your other post, show stops and post error.is that resolved? Link to comment Share on other sites More sharing options...
ksr Posted October 30, 2008 Author Share Posted October 30, 2008 No, with regard to the old post. I moved to my laptop and it runs fine. Have to assume at this point that is the desk top PC that is causing the problem. Link to comment Share on other sites More sharing options...
Recommended Posts