new pc lor network output problems

[berolec]

Hi everyone;

I have updated to a newer laptop running 64bit WIN10. Installed the lor suite version 3.7.2 (my old pc was running this version and my licence dose not go any higher)

Currently i am running 3x LOR 16ch dc boards set on units 01, 02, 03.

 Problems i am facing

-Anything above controller (unit) 2 does not recieve a signal (Tried multiple hardware and cable configurations / swaping the 16ch controller for a known working one. Tried different unit numbers. etc. All will work with LOR hardware utility but not when running a sequence)

-Visuliser will not show activity correctly above channel 32 (unit 2, ch 16). U3CH1 through 8 dont show at all and U3CH9 through 16 are intermittent at best.

 

The only thing that has changed is the pc. Ive uninstalled and re-installed LOR suite with no change.

 

I was previously running in 2017, 9x 16ch DC boards, 4x 24ch (RGB) DC boards, 1x 16ch AC board, LOR DMX converter and a hand full of AliExpress DMX 36ch dc boards. never with any issues untill now.

 

Any help would be greatly appreciated! :)