pouterson1 Posted December 7, 2019 Share Posted December 7, 2019 I need some advice on this issue. I have an LOR PIxel tree kit. I can see the tree in the HU and am able to light up all of the pixels. When I go into the Sequence Editor and create an animation scene, I can't get the tree to light up. I've checked the network setup and they match. I did have to swap the Pixie 8 and have it setup to the original address. There are no other devices near the address of the PIxie 8. I appreciate any help I can get on this. Paul Link to comment Share on other sites More sharing options...
TexasLights Posted December 7, 2019 Share Posted December 7, 2019 for the tree to light up in Sequence Editor, you need to start the control panel -- it should connect to the com port designated for the network the tree is on. Then launch SE and the control panel should say it is connected. Then if is setup right, you should be able to control it. Link to comment Share on other sites More sharing options...
Recommended Posts