Jump to content

no lights and music


gerald sundberg
 Share

Recommended Posts

gerald sundberg

The lights run fine on the hardware utility test, but I cant get them to run on test the show. we are enabled so it says, but dont hear or see anything. We cant even play the easy show builder, it says it's playing, but not on our test panel.

Link to comment
Share on other sites

close hardware utility. close the light bulb on the right hand corner. under sequence editor click play button. make sure control light is checked. make sure you have a steady led light on the controler and click play. see if you lights work. if they do, read up on hardware utilitly. you missed a step

http://www.lightorama.com/support.html

Link to comment
Share on other sites

gerald sundberg

Through the power of prayer, you people, and a patient son we now have a light show with music played on 107.1. I could give you all a huge hug Thanks Jerry

Link to comment
Share on other sites

  • 1 month later...
Carlos Barreto

I just went through the same problem, you need to select your port in your sequence editor and it will turn your lights and music on. In your sequence editor scroll down to preferences and set the correct port for your computer. I kept trying to change in in my hardware and it would never stay at the port I selected for my computer you also have to select your port in your editor and you should be good to go. Be sure to close out of your hardware first you can only run one program at a time. Make sure you click disable your shows I hope this helps.

Attached files 164654=9498-house and green tree.jpg

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...