sysco Posted October 1, 2019 Share Posted October 1, 2019 Can anyone tell me the which is the positive and which is the data the ground is marked in white dashes these are light o rama extensions thank you Link to comment Share on other sites More sharing options...
Rockhammer53 Posted October 2, 2019 Share Posted October 2, 2019 Typically the outside is +, middle is data and opposite side is - (marked) Link to comment Share on other sites More sharing options...
sysco Posted October 2, 2019 Author Share Posted October 2, 2019 28 minutes ago, Rockhammer53 said: Typically the outside is +, middle is data and opposite side is - (marked) thank you for your reply Link to comment Share on other sites More sharing options...
k6ccc Posted October 3, 2019 Share Posted October 3, 2019 I would get out a voltmeter and test. There is not much of a standard. Link to comment Share on other sites More sharing options...
TheDucks Posted October 3, 2019 Share Posted October 3, 2019 The Flat wire to the nodes might conform to + being the other side from the stripe. But use of the Volt meter confirms this if you cant see and read the attachment point markings inside the node . Add to this, there is NO STANDARD colors, even within LOR cables.. I bought a couple of DUMB RGB extension cables to make extra CMB24 pigtails (to allow different seasonal flood uses), The colors were off by 1 pin (4 pin connector). It did not matter when used as an extension. but did when cut to make pig tails. (lucky me, no smoke. ) And really watch out between light brands. Body Size, Pinout and threaded orientation (which is IN). Be sure to buzz it out if you deviate from the VENDORS off-the-shelf solutions Link to comment Share on other sites More sharing options...
sysco Posted October 3, 2019 Author Share Posted October 3, 2019 thank you for the information very helpful Jim - The Ducks Link to comment Share on other sites More sharing options...
Recommended Posts