2 props using same dmx address

[truelight]

I want to create a Prop that is laid out in 2 different ways. On one I want to build it using 'lines-unconnected' then I want to create the exact same Prop using 'Matrix-Vertical-Rectangle'. This allows me to use the same prop in two totally different ways... much like "Default" did here using 'nested' and 'preview'.

My Issue is that I can't figure out how to put the 2 Props on the same DMX address. Is this possible?

Thanks

[stevehoyt]

Not a DMX expert but take a look at the option in the channels area when you define the second identical prop. There is a selection right below the word channels that says uses the same channel as. It look like what you want and works in my small dmx test preview.