Jump to content

Lagging in Sequencer and Show


Rusty
 Share

Recommended Posts

For now I only have one 28 x 28 matrix (7 strands of 112 pixels) and one 70 pixel mini tree connected using a Pixcon 16 and I'm getting some serious lag while sequencing and if I run a quick show. Not sure if this has anything to do with it but I'm using last years preview and some of last years sequences. I have been using LOR for at least seven years, maybe more. V5.3.6 PRO, ELOR, 1000K. Should I get with the Help Desk and update my Pixcons? 

I tried 500K, different versions of the Pixcon16, swapped USB to 485 connectors (THE RED ONE's), different CAT5 cables, switched between Primary and Auxiliary networks, etc.  Any other suggestions would be greatly appreciated.

 

 

 

 

 

Link to comment
Share on other sites

  • Don locked this topic
Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...