Jump to content

enabled show disabling


Greg
 Share

Recommended Posts

Here is a new one, at least for me. I have a very simple show the has been running for a week or so. Today I noticed the show was disabled. I re-enabled it but when it should have started running it disabled itself. I began searching for the problem. I rebuilt the show, re did the schedule. When I tried to check the sequence itself I couldn't get the sequence editor to start. I am assuming that is the problem. I was just wondering if anyone else has seen this issue and how they got around it aside from a complete re-install. I am running 2.0.16.

thanks

greg

Link to comment
Share on other sites

Did that just start - as in 7/1/08? I bet your software expired.

Link to comment
Share on other sites

iresq,

Come to think of it you may be right I totally forgot about that. I do need to correct the last post. I had 2.0.14 installed not 2.0.16, ( I thought I did that but I only downlaoded and did not install yet) So I bet the expiration was the culprit. I will upgrade to 16 later tonight.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...