Inserting a falcon controller

[steve synek]

I am adding a falcon controller to my line up in SE.  I want to insert 16 new universes - 80 pixels in each of 16 consecutive universes.  Is there any reason why I can't insert a PixCon16 as the device and select the DMX settings when inserting the device to control the Falcon? ( I know I will have to set this up in the network settings- my question just applies to the actual sequencing side of things).

[Mr. P]

Yes, you should just be able to use the DMX settings. Just change the name of the group from Pixcon to whatever.

Edited June 24, 2017 by Mr. P

[Dennis Laff]

31 minutes ago, steve synek said:

I am adding a falcon controller to my line up in SE.  I want to insert 16 new universes - 80 pixels in each of 16 consecutive universes.  Is there any reason why I can't insert a PixCon16 as the device and select the DMX settings when inserting the device to control the Falcon? ( I know I will have to set this up in the network settings- my question just applies to the actual sequencing side of things).

Why would you limit your falcon controller to only using only 16 universes seem like a waste of all the other universes?

[steve synek]

Quote

1 hour ago, Dennis Laff said:

Why would you limit your falcon controller to only using only 16 universes seem like a waste of all the other universes?

Thanks!!  I'm a nut case about my wiring.........can't have all the spaghetti running around.  Controllers have to be located right by the props.  No extra wire for power injection at this house!!!!.