Can't enter simulation mode: Time is running backwards

[Lighted Christmas Balls]

I just started getting this error when trying to use the visualizer, which had worked fine for months. I am running v4.3.18 standard. I have rebooted several times, with no change. I saw some previous posts from 2015 here on this issue, but nothing recent. Help!

 

Sent from my SM-N910V using Tapatalk

 

 

[PhilMassey]

Read the When is a reboot not a reboot section Below..... Also check your clock is correct. May be a dead CMOS battery

 

[Lighted Christmas Balls]

I did check the clock and it is correct

Sent from my SM-N910V using Tapatalk

[BMurray]

Do a restart...NOT a power off/on. Powering off/on does not reset the internals. It saves the settings for the next power on cycle.  Once you restart is resets the settings. The backwards time thing will happen if you haven't done this in a while

[Lighted Christmas Balls]

Ok thanks I'll give that a try

Sent from my SM-N910V using Tapatalk

[Lighted Christmas Balls]

That was the ticket, restart fixed it, thanks so much for the advice. It's my first year setting up a light show so I have a lot to learn

Sent from my SM-N910V using Tapatalk