Configure CMB24D and 10W Spots

[cam308]

Trying to configure eight 10W spots connected to a CMB24D board for use in Pixel Editor as props.  If you take a look at the picture below, is that the correct way to be doing it?  What should max circuit be?  Would I do the same thing for the 50W spots, but just use each 50W as it's own unit id?

 

[Dennis Laff]

Each flood has the same unit #2 . But each flood has a different start channel.  First flood start channel 1.   Second flood.  Start channel 4. Third flood start channel 7.  Fourth flood start channel 10    Fifth start channel 13.    6 th . 16.      7th.  Start 19.    8th.  Start 22 . 

[cam308]

Thanks!

And the "Max Circuit" can stay at 24 for each?

[Dennis Laff]

Yes  24 is the channel amount for that controller ,