Jump to content

Set up my controllers wrong


JimCanfield
 Share

Recommended Posts

JimCanfield

I was just looking at my channel property grid and noticed that both controllers are unit one. In other words I have two unit 1 circuit 1 and two unit 1 circuit 2 and two unit 1 circuit 3 all the way to circuit 16.

Can I just change the units to 2 in the 16 circuits in the property grid? If I do that in this sequence, will it change all the other sequences as well? Or do I have to go through each sequence? Or perhaps, is there another way?

I am glad I noticed it now!

Link to comment
Share on other sites

Guest wbottomley

After fixing this sequence, go to the tool bar, click on edit, export channel config.

Then go to another sequence, click on edit, import channel config.

Link to comment
Share on other sites

JimCanfield

Ok thanks. This is now the 3rd channel config I have had to re-make due to mistakes. I am learning though, good thing it is not 2 weeks till light up!

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...