Little_b Posted November 17, 2016 Share Posted November 17, 2016 When I run HU to make sure all the controllers are connected and do some testing, it can only find 12 of my 14 controllers. The 2 that are missing are the last 2 connected in series, but not ID numerically (meaning it's missing unit 3 and unit 12). I have the Max Unit ID high enough to show all of them (and then some), and thinking it was a bad cat5e cable, I changed it out as well with no change. When I play a sequence and/or run the show in the scheduler, the 2 missing controllers perform just fine. Do I need to be worried of failure later on? When I set the Unit ID #'s I used 1-14 and skipped 0A - 0F would this make a difference? I didn't think it should. Thanks. Link to comment Share on other sites More sharing options...
Santas Helper Posted November 17, 2016 Share Posted November 17, 2016 IMO if they work just fine when running a sequence, I wouldn't worry about it. In the past, I have found the HU to not be 100% when finding controllers yet I don't have any issues when running sequences or my shows. Link to comment Share on other sites More sharing options...
Recommended Posts